To reset the oil change light, the specific steps vary by vehicle, but here are the common general methods:
- Using Dashboard Controls:
- Turn the ignition to the "On" position without starting the engine.
- Find the oil change reminder screen or oil life display.
- Press and hold the "Reset" or "Info" button on the dashboard or steering wheel until the oil life indicator starts blinking.
- Release the button and then press and hold it again until the light resets and disappears.
- Manual Reset Procedure (for older vehicles):
- Turn the ignition to the "On" position without starting the engine.
- Fully depress and release the accelerator pedal three times within 10 seconds.
- Turn off the ignition and start the engine to verify the reset.
- Using an OBD-II Scanner (for complex electronic systems):
- Connect the OBD-II scanner to the diagnostic port.
- Turn the ignition to "On."
- Use the scanner menu to find and select the 'Reset Oil Life' option and follow prompts.
Specific steps for popular brands:
- Honda (2007+): Accessory key position, use the "Select/Reset" button, hold for 10 seconds until blinking, release and hold again until 100%.
- Toyota: Turn key to "On", press and hold trip meter reset button, turn key off then back to "On" while holding button until zeros appear.
- Ford: Use "Setup" and "Reset" buttons to find and reset oil life settings on the display.
Always consult the vehicle’s owner manual for model-specific instructions, and if the light remains on after resetting, further mechanical inspection is advised. These are standard procedures to reset the oil change light after an oil change has been completed to keep timely maintenance tracked.
